OpenWii v2.4 for Atmega8 (Chiip)
OpenWii users will be happy to know that the team behind the project has just released a new build, bumping the open-source modchip up to version 2.4. Note that this release is for the Atmega8 (Chiip).
There have been many changes since the last release so to keep yourselves updated, view the changelog at the full article after the jump!
Download: OpenWii2.4 Auto Programmer
Download: OpenWii2.4 Setup PAL
Download: OpenWii2.4 Setup NTSC
Download: OpenWii2.4 Setup JAP
Download: OpenWii2.4 Dol (for SD load)
Download: OpenWii2.4 Source
Download: OpenWii2.4 Setup Source
Nintendo Wii homebrew developer andii has announced the release of a new build for the open-source modchip OpenWii, bumping the project up to version 2.4.
This is still for Atmega8 (Chiip). Anyway, andii has highlighted the many changes that were implemented to this specific build. They are as follows:
- Audiofix
- DualLayer Support
- New LED blink codes (L = long blink, S = short blink)
- New setup disc behavior
- The chip update is now starting automatically if no GameCube controller is connected.
- If you want to change your configuration, ensure to connect a GameCube controller in port 1 before starting the Setup Disc!
Power Up: L S
Drive Patched: L S S (e.g. each disc change)
Set Region / Speed / Audifix: L S S S (using setup disc)
Upgrade Firmware: LED flashes (update is finished when led is off)
What we have below are several download packages for different SKUs. Please be sure that you are getting the file that suits your system to avoid any problems.
Download: OpenWii2.4 Auto Programmer
Download: OpenWii2.4 Setup PAL
Download: OpenWii2.4 Setup NTSC
Download: OpenWii2.4 Setup JAP
Download: OpenWii2.4 Dol (for SD load)
Download: OpenWii2.4 Source
Download: OpenWii2.4 Setup Source
Via OpenWii
About The Author
