PSP-Devolution modchip available already
In case you’ve forgotten, we would like to remind you that PSP-Devolution’s USB-JTAG Programmer for a lot of NAND FLASH ICs (aka modchip) is finally available. Actually, sales started last April 16 and will end on April 20. The delay was caused by an important improvement involving a 4-layer technology that makes the chip even smaller.
Also, the team behind this creation mentioned that the chip has actually two versions. The first one is a 3.3V version that works for PlayStation Portable (PSP) motherboards TA-079 to TA-081. The other one is a 1.8V version that is compatible to TA-082+ boards. That means TA-086 users are covered too.
We’ve already posted the PSP-Devolution modchip features before but for the benefit of those who missed it, we listed them down again below.
- Flash your PSP using the internal USB Port
- No additional USB Port required
- Latest ACTEL ProASIC 3 technology
- NO power consumption
- Doesn’t touch the battery power in any way, powered by USB for the time being used to flash the PSP
- Pre-assembled hi-tech flex pcb for easiest possible connection to the psp main board
- Works on all available PSP versions incl. the new TA-082 and TA-086
- Custom BIOS with a lot of cool additional features
In case you’ve forgotten, we would like to remind you that PSP-Devolution’s USB-JTAG Programmer for a lot of NAND FLASH ICs (aka modchip) is finally available. Actually, sales started last April 16 and will end on April 20. The delay was caused by an important improvement involving a 4-layer technology that makes the chip even smaller.
Also, the team behind this creation mentioned that the chip has actually two versions. The first one is a 3.3V version that works for PlayStation Portable (PSP) motherboards TA-079 to TA-081. The other one is a 1.8V version that is compatible to TA-082+ boards. That means TA-086 users are covered too.
We’ve already posted the PSP-Devolution modchip features before but for the benefit of those who missed it, we listed them down again below.
- Flash your PSP using the internal USB Port
- No additional USB Port required
- Latest ACTEL ProASIC 3 technology
- NO power consumption
- Doesn’t touch the battery power in any way, powered by USB for the time being used to flash the PSP
- Pre-assembled hi-tech flex pcb for easiest possible connection to the psp main board
- Works on all available PSP versions incl. the new TA-082 and TA-086
- Custom BIOS with a lot of cool additional features
About The Author
